Partial
Bambu Lab Support for ABS on the Kobra 3 Max
FilamentFacts may earn a commission when you buy through links on this page. As an Amazon Associate we earn from qualifying purchases.
- Nozzle—
- Bed80–100 °C
- Speedup to 100 mm/s
- Dry80 °C for 4 h
- Density1.16 g/cm³
Bed 80–100 °C. No nozzle temperature on the source. Dry 4 h at 80 °C if it's been open. Listed speed up to 100 mm/s.
Kobra 3 Max maximums: nozzle 300 °C, bed 90 °C.
Sources & notes
Anycubic Kobra 3 Max with Bambu Lab Support for ABS: The listed bed range reaches 100 °C, above this printer's maximum of 90 °C. This printer cannot reach the full recommended range. The low end, 80 °C, is within that maximum.
Dataset imported 13 October 2026. Manufacturer page checked 14 October 2026.
Bambu Lab Support for ABS technical data sheet · checked 14 October 2026 · Printer source · Filament JSON
The quick start lists a 300 °C maximum nozzle temperature and a 90 °C maximum heatbed temperature. The Combo includes the ACE Pro.
The FAQ recommends setting up a warm chamber for ABS, so the stock printer is recorded as open. Nozzle alloy and drive type are not stated.
Questions
Can the Anycubic Kobra 3 Max reach the listed Support for ABS nozzle temperature?
Nozzle temperature is not in our current sources.
Can the Kobra 3 Max reach the listed bed temperature?
The listed bed range reaches 100 °C, above this printer's maximum of 90 °C. This printer cannot reach the full recommended range. The low end, 80 °C, is within that maximum.
Is an enclosure required?
Whether an enclosure is required is not in our current sources.
Is a hardened nozzle recorded?
A hardened nozzle is not recorded for this filament.