Partial
Bambu Lab Support for PA/PET on the A1 mini
FilamentFacts may earn a commission when you buy through links on this page. As an Amazon Associate we earn from qualifying purchases.
- Nozzle260–290 °C
- Bed80–100 °C
- Speed—
- Dry80 °C maximum
- Density1.17 g/cm³
Print at 260–290 °C nozzle, 80–100 °C bed. Dry at 80 °C if it's been open. No drying time on the source.
A1 mini maximums: nozzle 300 °C, bed 80 °C.
Sources & notes
Bambu Lab A1 mini with Bambu Lab Support for PA/PET: The listed bed range reaches 100 °C, above this printer's maximum of 80 °C. This printer cannot reach the full recommended range. The low end, 80 °C, is within that maximum.
Dataset imported 13 October 2026. Manufacturer page checked 14 October 2026.
Bambu Lab Support for PA/PET technical data sheet · checked 15 October 2026 · Printer source · Filament JSON
Bambu Lab lists a 300 °C maximum hot end temperature, an 80 °C maximum build plate temperature, and a stainless steel nozzle.
The FAQ says a hardened steel nozzle is required for carbon-fiber or glass-fiber filament and is not the pre-installed nozzle.
Enclosure is not stated on the specification table checked here.
Questions
Can the Bambu Lab A1 mini reach the listed Support for PA/PET nozzle temperature?
The listed nozzle maximum of 290 °C is within this printer's maximum of 300 °C.
Can the A1 mini reach the listed bed temperature?
The listed bed range reaches 100 °C, above this printer's maximum of 80 °C. This printer cannot reach the full recommended range. The low end, 80 °C, is within that maximum.
Is an enclosure required?
Whether an enclosure is required is not in our current sources.
Is a hardened nozzle recorded?
A hardened nozzle is not recorded for this filament.