Partial
ELEGOO PLA Glow on the A1 mini
FilamentFacts may earn a commission when you buy through links on this page. As an Amazon Associate we earn from qualifying purchases.
- Nozzle190–230 °C
- Bed35–65 °C
- Speed—
- Dry55 °C maximum
- Density1.24 g/cm³
Print at 190–230 °C nozzle, 35–65 °C bed. Dry at 55 °C if it's been open. No drying time on the source.
A1 mini maximums: nozzle 300 °C, bed 80 °C.
Sources & notes
Bambu Lab A1 mini with ELEGOO PLA Glow: This filament is carbon-fiber, glass-fiber, or glow-in-the-dark, so a hardened nozzle is the upgrade to check. The stock nozzle is not hardened.
Dataset imported 13 October 2026. Manufacturer page checked 14 October 2026.
Filament source · Printer source · Filament JSON
Bambu Lab lists a 300 °C maximum hot end temperature, an 80 °C maximum build plate temperature, and a stainless steel nozzle.
The FAQ says a hardened steel nozzle is required for carbon-fiber or glass-fiber filament and is not the pre-installed nozzle.
Enclosure is not stated on the specification table checked here.
Questions
Can the Bambu Lab A1 mini reach the listed PLA Glow nozzle temperature?
The listed nozzle maximum of 230 °C is within this printer's maximum of 300 °C.
Can the A1 mini reach the listed bed temperature?
The listed bed maximum of 65 °C is within this printer's maximum of 80 °C.
Is an enclosure required?
Whether an enclosure is required is not in our current sources.
Is a hardened nozzle recorded?
This filament is carbon-fiber, glass-fiber, or glow-in-the-dark, so a hardened nozzle is the upgrade to check. The stock nozzle is not hardened.