Partial
Inland Glow ABS on the A1
FilamentFacts may earn a commission when you buy through links on this page. As an Amazon Associate we earn from qualifying purchases.
- Nozzle230–260 °C
- Bed90–110 °C
- Speed—
- Dry—
- Density1.04 g/cm³
Print at 230–260 °C nozzle, 90–110 °C bed.
A1 maximums: nozzle 300 °C, bed 100 °C.
Sources & notes
Bambu Lab A1 with Inland Glow ABS: The listed bed range reaches 110 °C, above this printer's maximum of 100 °C. This printer cannot reach the full recommended range. The low end, 90 °C, is within that maximum.
Dataset imported 13 October 2026. Manufacturer page checked 14 October 2026.
Filament source · Printer source · Filament JSON
The A1 FAQ states a maximum hotend temperature of 300 °C and a maximum heatbed temperature of 100 °C.
The same FAQ says the printer is pre-installed with a 0.4 mm stainless steel nozzle. Hardened steel nozzles are sold separately.
The FAQ does not call the frame open or enclosed, so enclosure is left empty.
Questions
Can the Bambu Lab A1 reach the listed Glow ABS nozzle temperature?
The listed nozzle maximum of 260 °C is within this printer's maximum of 300 °C.
Can the A1 reach the listed bed temperature?
The listed bed range reaches 110 °C, above this printer's maximum of 100 °C. This printer cannot reach the full recommended range. The low end, 90 °C, is within that maximum.
Is an enclosure required?
Whether an enclosure is required is not in our current sources.
Is a hardened nozzle recorded?
This filament is carbon-fiber, glass-fiber, or glow-in-the-dark, so a hardened nozzle is the upgrade to check. The stock nozzle is not hardened.