Partial
Bambu Lab ASA-CF on the P1S
FilamentFacts may earn a commission when you buy through links on this page. As an Amazon Associate we earn from qualifying purchases.
- Nozzle—
- Bed80–100 °C
- Speedup to 250 mm/s
- Dry80 °C for 8 h
- Density1.02 g/cm³
Bed 80–100 °C. No nozzle temperature on the source. Dry 8 h at 80 °C if it's been open. Listed speed up to 250 mm/s.
P1S maximums: nozzle 300 °C, bed 100 °C.
Sources & notes
Bambu Lab P1S with Bambu Lab ASA-CF: This filament is recorded as needing a hardened nozzle. The stock nozzle is not hardened.
Dataset imported 13 October 2026. Manufacturer page checked 14 October 2026.
Bambu Lab ASA-CF technical data sheet · checked 14 October 2026 · Printer source · Filament JSON
The P1S specification table lists a stainless steel nozzle, a 300 °C maximum hot end, and a 100 °C maximum build plate. The shell is plastic and glass.
Bambu Lab describes the P1S as a fully enclosed body and says fiber-reinforced filament is not recommended until the extruder and hotend are upgraded.
The P1 series page describes a direct-drive extruder and AMS multi-color printing.
Questions
Can the Bambu Lab P1S reach the listed ASA-CF nozzle temperature?
Nozzle temperature is not in our current sources.
Can the P1S reach the listed bed temperature?
The listed bed maximum of 100 °C is within this printer's maximum of 100 °C.
Is an enclosure required?
Whether an enclosure is required is not in our current sources.
Is a hardened nozzle recorded?
This filament is recorded as needing a hardened nozzle. The stock nozzle is not hardened.